Boss Controller

The boss range is Joules Exhaust Air Heat Pump local supervisor solution for small, medium, and large systems, featuring built-in Wi-Fi and access from all mobile devices. Access to all boss pages for both programming and everyday operations using mobile devices has in fact been made possible thanks to the responsiveness of its pages.

• Completely browsable from mobile devices, from commissioning to daily access for system maintenance.
• Built-in Wi-Fito creates a network and allows the supervisor to access the user’s devices without requiring other network infrastructure.
• All the information is available to the user in just a few simple clicks, including system configuration and device management.
• Centralised management through automatic data and alarm synchronisation with RemotePRO.
• Communication with BACnet and SNMP protocols allow the integration of third-party devices and integration of the boss supervisor into BMS systems
• User interfaces with customisable graphics based on how the information is required by different users

Our detailed BOSS BIM families are available to start working into 3D building information modelling programs such as Autodesk REVIT. BIM modelling enables better project planning and thereby ensures accuracy. It will provide accurate cost estimates for early project certainty enhances operations, maintenance, and facility management.

BOSS controller will form part of a network when integrated with a BMS. This is achieved using CAT6a SFTP or equivalent cable from each EAHP apartment unit to plant room (via a switch per floor or block), the BOSS controller connects into the final switch. Network communication to the BOSS controller is created by issuing addresses (IP, Gateway etc.) specific to each apartment and set during commissioning.

Integration of third party devices: This new feature significantly increases the possibility to integrate third party devices. The BACnet Master protocol is available in both MS/TP (RS485) and TCP/IP modes, and together with the Modbus RS485 and Modbus TCP/IP protocols, these too available on boss, offers the possibility to interact with the widest range of devices in the HVAC/R sector.

BMS integration: In addition to Master mode, the BACnet protocol is also available on boss in TCP/ IP Slave mode, allowing boss to be integrated into a higher-level BMS, sharing the values of interest for overall building management (e.g. unit status, alarm status, ON/OFF controls,

Boss always in your pocket:  Responsive web pages offer the possibility to access all boss pages for both programming and everyday operations using mobile devices.

Centralised management: Boss permits automatic data and alarm synchronisation with RemotePRO, so as to keep the situation on all connected systems under control from just one interface.

Remote service Access: To typical operating system functions, such as printer driver installation, copying files, etc. is also available via a web interface, another first for a supervisory system.